Buffalo Drill Press

Description

This drill press runs great! It is a nice, clean, well maintained machine. It's just too big for my little shop.
The motor is dual voltage, 220/440 3 Phase, currently wired for 220. The pulleys are 4 step. It's 14" from the center of the spindle to the table bracket. The work table surface is 23" wide and 21 1/2" from front to back. Unfortunately the switch/starter box is mounted over the information cast into the headstock so I do not know the model number, or even if a model number is present.
The drill press comes with a Jacobs 2A chuck, capacity 0 - 3/8", the chuck key is included also. The spindle is a No. 2 Morse taper.
I can help load the machine, I have a gantry to lift it, but the lower the deck height on your trailer or truck the better. In fact I cannot lift it high enough to go into the bed of a pick up. Please take this into consideration before purchasing the machine. I will not be responsible if we are not able to get the machine loaded with my equipment. The deck height of my trailer (which I was able to unload it from) is about 20" so that should give you a maximum height...
You can hear it run and try it out before you buy it. You should allow a couple of hours (that's how long it took me by myself) for moving the machine from my shop and getting it loaded unless you bring strong help. This thing is VERY heavy.
I'm always happy to provide more information or photos, just let me know what you need.
Offers are cheerfully reviewed, many are cheerfully accepted. Please note this machine is also listed locally.
Thank you for looking and I wish you the very best in all things!